Installer for atprogram only?

Go To Last Post
5 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hi,

The project is close to the finish line. ( 8) ). Now, I need to write instructions to the factory. is there a separate installer for atprogram, or must the factory install the full Studio6?

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

You can zip up and send them the avrdbg folder out of your local AS6 installation, along with the drivers. I think we used to have a standalone installer for it at one point - perhaps email AVR support so we can dig it up for you.

- Dean :twisted:

Make Atmel Studio better with my free extensions. Open source and feedback welcome!

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

abcminiuser wrote:
... email AVR support ...

Dean, what is the email address? I tried last month on another subject and it bounced.

Cheers,

Ross

Ross McKenzie ValuSoft Melbourne Australia

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

For regular customers, it's avr at atmel.com, or avr32 at atmel.com. There was a failure in the mailing system a while back that rejected emails for two days, so perhaps you were unlucky and tried on one of those two days.

- Dean :twisted:

Make Atmel Studio better with my free extensions. Open source and feedback welcome!

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Thanks Dean. I will send it off again.

Cheers,

Ross

edit. Sent it off. And got, in my opinion, a stupid reply. Will not make that mistake ever again.

Ross McKenzie ValuSoft Melbourne Australia