First of all I'm glad to be here.
I'm newbie here and on microcontrollers too.
Well, I have an old V8 Jlink, and my project is to use SPI output to read an SD card with 1bit only.
I have good skills in electronics and soldering, but few experiences in programming.
Is it possible to implement or convert this "black brick" in my project?
Board Microcontroller is AT91SAM7S64
I'd like to use SPI output:
nReset (if Possible)
Here is log from V8 and pic:
Firmware: J-Link ARM V8 compiled Nov 28 2014 13:44:46
Hardware version: V8.00
J) JTAG (Default)