Just registered here and complete newbie to everything microcontroller programming world! I have though experience with PLCs and motor controllers.
Let me know if this section of the forum is not suitable for what I am asking.
I sourced a board with an atmega2560 controller from an old 3d printer. I want to try and program it but I have no idea where to start from or if its even possible to do so.
I tried the arduino IDE for which I had no luck. What do you think I should go about it? Is there any software I could use to program a "generic" board?
Another issue is, I don't have a clue what IO is on the board. Is there any way I could copy the program of the controller and save it on my pc for further digging?
Thanks in advance!