Error: unable to open ftdi device with vid 0403, pid 6010, description 'NGX JTAG', serial '*' at bus location '*'

1 post / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

When we tried to run OPENOCD Using FT2232H Adapter for SWD Debugging in SAMA5D36 board 
it is throwing the following error. 

root@yash01-desktop:/home/yash01/Documents/openocd-bin# openocd -f interface/ftdi/ngxtech.cfg -f target/sama5d36.cfg 
Open On-Chip Debugger 0.10.0 
Licensed under GNU GPL v2 
For bug reports, read 
http://openocd.org/doc/doxygen/bugs.html 
WARNING! 
This file was not tested with real interface, but is assumed to work as this 
interface uses the same layout as configs that were verified. Please report your 
experience with this file to openocd-devel mailing list, so it could be marked 
as working or fixed. 
trst_and_srst separate srst_gates_jtag trst_push_pull srst_open_drain connect_deassert_srst 
adapter speed: 1500 kHz 


Info : auto-selecting first available session transport "jtag". To override use 'transport select <transport>'. 
eMMC{ 
Error: no device found 
Error: unable to open ftdi device with vid 0403, pid 6010, description 'NGX JTAG', serial '*' at bus location '*' 

Please give me a solution for fixing this issue. Any help will be appreciated. 

Thanks in Advance 

Ravi

Last Edited: Fri. Dec 14, 2018 - 11:45 AM