eeprom and bod

Log in or register to post comments
Go To Last Post
3 posts / 0 new
Author
Message
schickb
schickb's picture
Level: Hangaround
Joined: Mon. May 7, 2007
Posts: 291 View posts
Location: Seattle
#1
Posted by schickb: Thu. May 7, 2009 - 02:15 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

The datasheet for the at90usb162 (and others) talks about preventing eeprom corruption by enabling the internal brown-out detector. But I haven't found anything that says what the BOD voltage trigger should be.

Should I just assume that any level under which the cpu itself functions is safe for eeprom operations?

-Brad

Tags:

AVR Microcontrollers, megaAVR and tinyAVR
Top
Bronze Markjs
js's picture
Level: Moderator
Joined: Wed. Mar 28, 2001
Posts: 29676 View posts
Location: Sydney, Australia (Gum trees, Koalas and Kangaroos, No Edelweis, but plenty of Corona beer)
Posted by js: Thu. May 7, 2009 - 02:20 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Quote:
I haven't found anything that says what the BOD voltage trigger should be.
Well you only have a choice of about 3 or 4 from the dropdown menu, set it as high as you can for your VCC lelel. Say 4.3V for a 5V system etc.

John Samperi

Ampertronics Pty. Ltd.

www.ampertronics.com.au

* Electronic Design * Custom Products * Contract Assembly

Top
schickb
schickb's picture
Level: Hangaround
Joined: Mon. May 7, 2007
Posts: 291 View posts
Location: Seattle
Posted by schickb: Thu. May 7, 2009 - 03:40 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

js wrote:
Well you only have a choice of about 3 or 4 from the dropdown menu, set it as high as you can for your VCC lelel. Say 4.3V for a 5V system etc.

Actually there are 7 choices (not included off), but only 3 are below my Vcc target of 3v3. I guess I'll do as you suggest and select the highest one within that range (3.0) and hope that's good enough for eeprom writing.

-Brad

Top