Data visualization

Go To Last Post
5 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I have installed Atmel 7 together with visual micro and use the Amel-ICE  ( concern the Arduino DUE )

What I still can't do is data visualization at full speed with the graph window.

 

To test the Data visualiser program I use the Arduino AnalogInput sample program.

Furthermore I have used the debugger program to find out what the addres is of the analog input valeu ( in my case that is 200704c8 )

 

Then I started the Data visualizer, and CONNECT the Atmel data gateway.

Then I go to Code profiling an than to Configure interface.

In window Code Profiling Configurations I add the data adress 0x200704c8.

Then I open the Gaph window and put the measure pin in New plot.

Afther this I get no plot signal on the Graph window.

 

I hope this is clear what did.

 

I would also like some tips so that the signal will be plotted.

Last Edited: Wed. Feb 2, 2022 - 04:24 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Welcome to AVRFreaks!

 

Leendert wrote:
To test the Data visualiser program I use the Arduino AnalogInput sample program.

Have you modified the sketch so it does more then just blink and LED at a rate set by the Analog Input value?

 

Have you tried using the Arduino IDE graphing tools:  Tools/Serial Plotter     but even that will require you to send the data out the serial port formatted correctly!

 

Before this turns into an X-Y problem, can you backup and tells us what it is you are trying to accomplish (ie. the big picture) rather then some small piece of the puzzle presented above....

 

Jim

 

 

FF = PI > S.E.T

 

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hi,

 

Because I want to make my own pcb with the ATMEL ATSAM 3X8E processor and only add the serial USB Netive port and the JTAG port.  (so I can't use the serial monitor with the arduino IDE,  and it doesn't make the design so complex)

For programming and debugging I want to use the ATMEL-ICE with the JTAG port.

I have tested programming and debugging with the ATMEL-ICE and it works.

What I'm not working yet is data visualization at full speed with the graph window.

So the question is is it possible to use the graph window with the data visualzation possibility.   ( At full speed like the serial monitor with the arduino IDE )

 

I hope this is a bit clearer where I'm going.

 

"<

  // This is the test program

  http://www.arduino.cc/en/Tutoria...
*/

int sensorPin = A0;    // select the input pin for the potentiometer
int ledPin = 13;      // select the pin for the LED
int sensorValue = 0;  // variable to store the value coming from the sensor

void setup() {
  // declare the ledPin as an OUTPUT:
  pinMode(ledPin, OUTPUT);
}

void loop() {
  // read the value from the sensor:
  sensorValue = analogRead(sensorPin);
  // turn the ledPin on
  digitalWrite(ledPin, HIGH);
  // stop the program for <sensorValue> milliseconds:
  delay(sensorValue);
  // turn the ledPin off:
  digitalWrite(ledPin, LOW);
  // stop the program for for <sensorValue> milliseconds:
  delay(sensorValue);
}

>"