Data Visualiser: re-load previously saved data?

1 post / 0 new
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0


This doesn't really seem to fit any of the available forum categories; posted here as it is about "debugging" (and there is a "Power Debugger")


Talking specifically about the Standalone version:

though I imagine the one within MPLAB would be the same?


I'm using the Standalone Data Visualiser to capture current consumption data (using a SAML21 XPro board, but the target is AVR), and analyse that data.


It can save the raw data to a CSV file. Having done that, it would be good to be able to read the data back in to the Visualiser for further analysis.


So the question is: is it possible to read-in previously saved (CSV) data ?


And, if it is, how? (I can't seem to find it).



Top Tips:

  1. How to properly post source code - see: - also how to properly include images/pictures
  2. "Garbage" characters on a serial terminal are (almost?) invariably due to wrong baud rate - see:
  3. Wrong baud rate is usually due to not running at the speed you thought; check by blinking a LED to see if you get the speed you expected
  4. Difference between a crystal, and a crystal oscillator
  5. When your question is resolved, mark the solution:
  6. Beginner's "Getting Started" tips:
Last Edited: Thu. Sep 30, 2021 - 11:02 AM