Can't generate the code from Atmel START during Reconfigure.

Log in or register to post comments
Go To Last Post
3 posts / 0 new
Author
Message
sam_vir
sam_vir's picture
Level: New Member
Joined: Wed. Sep 9, 2020
Posts: 16 View posts
#1
Posted by sam_vir: Thu. Feb 11, 2021 - 08:34 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hi All,

 

I have been facing an issue with Atmel Start which is quite strange.

I created a new project for AVR controller with Atmel Start and after sometime I tried to reconfigure by adding some new software module like ADC etc. But when I tried to generate the project again I got following error pop -up message on my screen.

 

 "The current project is NOT an Atmel Start project"

 

I tried to do the same for an old project which was created around 3 month ago and it worked fine.

 

I have upgraded to MICROCHIP STUDIO after this but still the issue persist.

 

 

Regards,

 

#Learning AVR step by step

Tags:

Tools, Atmel Studio (AVR-related)
Last Edited: Thu. Feb 11, 2021 - 08:36 PM
Top
ki0bk
ki0bk's picture
Level: 10k+ Postman
Joined: Mon. Sep 8, 2014
Posts: 10609 View posts
Location: Over the rainbow
Posted by ki0bk: Fri. Feb 12, 2021 - 05:45 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 1

Have you reported your issue to MicroChip support?

 

What chip are you trying to use with Atmel Start?

 

FF = PI > S.E.T

 

Top
sam_vir
sam_vir's picture
Level: New Member
Joined: Wed. Sep 9, 2020
Posts: 16 View posts
Posted by sam_vir: Sun. Feb 14, 2021 - 08:11 PM (Reply to #2)
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

ki0bk wrote:

Have you reported your issue to MicroChip support?

 

What chip are you trying to use with Atmel Start?

 

I haven't yet.

 

I installed MICROCHIP Studio & so far don't have that problem any more.

 

But still I will report it.

 

I am using ATmega324pb.

 

Thanks,

#Learning AVR step by step

Top