boot error : Unknown node type: e002

Go To Last Post
2 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

hello. Yesterday my second ngw100 board dropped dead on me. when I boot I get :

U-Boot 1.1.4-at0 (Jan  3 2007 - 10:30:09) 

U-Boot code: 00000000 -> 000144f7  data: 24000000 -> 24002d80
SDRAM: 32 MB at address 0x10000000
Testing SDRAM...OK
malloc: Using memory from 0x11fc0000 to 0x12000000
Flash:  8 MB at address 0x00000000
DRAM Configuration:
Bank #0: 10000000 32 MB
In:    serial
Out:   serial
Err:   serial
Net:   macb0, macb1
Press SPACE to abort autoboot in 1 seconds
### JFFS2 loading 'uImage' to 0x10200000
Scanning JFFS2 FS: ......./ Unknown node type: e002 len 2736 offset 0x79a038
 done.

### JFFS2 load complete: 912671 bytes loaded to 0x10200000
## Booting image at 10200000 ...
   Image Name:   Linux-2.6.18-atngw
   Image Type:   AVR32 Linux Kernel Image (gzip compressed)
   Data Size:    912607 Bytes = 891.2 kB
   Load Address: 10000000
   Entry Point:  90000000
   Verifying Checksum ... Bad Data CRC
Uboot> 

I can boot, loading manual the uImage, but I want to fix this. What is the most easy way (and simple also ) :D to fix this.

Please put the code line, if you know and have mercy . I really need the second board too.

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

fix -it. reinstall the root folder. see wiki.