AvrOsp II works only once...

Go To Last Post
7 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hi to all!

I built an AN910/911 compatible AVR USB programmer (a project from a Russian guy named Protoss).

The hardware works amazingly with CodeVisionAVR, AVRPROG 1.4 and AVROSP(command-line one).

BUT I don't like to use it with CodeVision, because the fuses programming is very annoying with it...And AVRProg doesn't have ATMEGA48, ATMEGA88, etc.....

The perfect Solution to me would be the AVROSP II, the complete GUI with all devices that I need...

Here is the problem: ALL versions that I tried, just send the correct command one time to the programmer, and after that, it seems that the programmer hangs...It is not even detected anymore....The only solution is to unplug and plug it again, so i can send another alone commmand to it....But it repeats the error, receiving only one command...
NOTE: with the first command sent, the programmer response i always OK(for example, it detects the right device, or the right fuses that was in the device)

It's very strange, but this also happens with BASCOM....Exactly the same....

Anyone here has noticed that??

Thank you guys!

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

The link to the programmer (schematics, etc) is:
http://prottoss.com/projects/AVR910.usb.prog/avr910_usb_programmer.htm

in the case of you guys want to build one too.

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

hey guys i have problem with this avr protoss programer.

I use with windows os, it's work fine, but can not work with linux ubuntu machine.

I have tried ubuntu 7.10, 8.10 and 9.04 all of them fail to give me a perfect work.

what Should I do ?

Is there any driver for linux ubuntu ?

thank for attention.

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Quote:
hey guys i have problem with this avr protoss programer.

Which software do You use for programming with it?

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

does the protoss one support atmega324p

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

it doesnt say whether prottoss programmer support atmega324p, i mean does the programmer depend on the software used (i.e avrstudio) whether it supports atmega324p, or hardware wise is there a limit.. cos atmega324p is only an advanced version of atmega32.. which this programmer supports..