AVRDragon, debugWire, AS6.1 and ATMega328P

Log in or register to post comments
Go To Last Post
4 posts / 0 new
Author
Message
antoniordz
antoniordz's picture
Level: New Member
Joined: Wed. Feb 20, 2013
Posts: 17 View posts
#1
Posted by antoniordz: Sun. Jun 30, 2013 - 02:36 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I got this configuration working in a breadboard, along with cristal, no capacitor on pulled up reset, and external 3V.

AS can go into debugWire without problem, but it cannot go back because for some reason it cannot un-program DWEN.
When it is running and I select disable debugWire and close, it tries and at the end it gives me a "Feil to disable debugWire: The tool specified has been disconnected..."

Could someone tell me what could be happening?

Thanks,

Tags:

AVR Microcontrollers, megaAVR and tinyAVR
Top
Silver Markclawson
clawson's picture
Level: Moderator
Joined: Mon. Jul 18, 2005
Posts: 99904 View posts
Location: (using avr-gcc in) Finchingfield, Essex, England
Posted by clawson: Sun. Jun 30, 2013 - 10:03 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

You have ALL the ISP wires connected?

Top
antoniordz
antoniordz's picture
Level: New Member
Joined: Wed. Feb 20, 2013
Posts: 17 View posts
Posted by antoniordz: Sun. Jun 30, 2013 - 10:38 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Yes, so AS can sense the voltage trough Vcc and adjust. It works perfectly for debugging, even programming it using the debugger, the only problem is that I cannot get DWEN off so I cannot change anything else, unless I HVPP it

Top
IAM_Carbon_Based
IAM_Carbon_Based's picture
Level: New Member
Joined: Sat. Mar 9, 2013
Posts: 7 View posts
Posted by IAM_Carbon_Based: Thu. Jul 4, 2013 - 01:30 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

make sure the reset line is tied high with a 10K resistor. Double check the ISP connections, if the MSIO, MOSI, and CLK line are not right you will get that message. That one got me for a bit.

Top