AVR Dragon & ATTiny13

Go To Last Post
3 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I recently bought a Dragon Board and had picked up some Attiny13V and Attiny13A from mouser, but when I try to read the device I get the following message and cannot make any changes to program the new chips.

Timestamp:	2006-07-20 17:36:38.234
Severity:		ERROR
ComponentId:	20000
StatusCode:	0

No supported device matches device signature (0x80 0x01 0x0F) nor JTAG ID (0x00 0x00 0x00 0x00)

Do I have to switch the tool to HVIP in order to program the chips?

Thanks,

Bill

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Make sure your Tiny is properly wired and powered, Dragon programming mode set to ISP, and the Dragon ISP frequency set to 125 kHz or below.

Warning: Grumpy Old Chuff. Reading this post may severely damage your mental health.

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I set the the ISP frequency to 125 KHz and all is good!

Thanks :),

Bill