Has anyone else noticed that avarice seems MUCH slower than AVR Studio when it comes to JTAG debugging? With studio 4 steps are almost instant, with avarice it seems to take a couple of seconds.
I have tried fiddling with the -B command line parameter but I have no idea what the units are... I have tried 1000, 1MHz, 1000000 (this one was unstable, and did not work), 1000kHz...
I am not sure what is left to try. In studio the jtag frequency is 1 MHz and it works wonderfully.
Any advice would be greatly appreciated.
p.s. "Use AVR Studio 4" is not the advice I am looking for :)