Attiny817 Xplained pro can't connect to DGI

1 post / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

 

Hello,

 

the data visulizer was working fine with my Attiny817 Xplained pro. However, After trying to start the code profiling interface along with the power interface, Atmel studio 7 stoped responding. Therefore I had to force Atmel to stop then safely eject the attiny817 board. After that, whenever I try to connect to the DGI in the data visulizer nothing happens and the interfaces are not detected as shown in the screenshot below. Yet, I can still code and debug as before. Also, I can still connect to the serial port in the data visulizer . is there any way I can fix this ?

 

 

Attachment(s): 

Last Edited: Sat. Jul 25, 2020 - 09:08 AM