ATMega8 for remote control

Go To Last Post
3 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

How to create remote control device for control JVC XV-N212S and  ProLine DVD 1280 dvd players using Atmega8A/16/Attiny2313? How to flash it using ExtraPic 2 with AVR support? How to set fuses, what source codes/.hex for PonyProg 2000 2.08  are needs for this device? How to connect buttons and LED buffer to this IC, which fosc is necessary ? How to use FT232BL /CP210x for flashing via USB ?

Last Edited: Fri. Nov 24, 2017 - 06:40 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Top Tips:

  1. How to properly post source code - see: https://www.avrfreaks.net/comment... - also how to properly include images/pictures
  2. "Garbage" characters on a serial terminal are (almost?) invariably due to wrong baud rate - see: https://learn.sparkfun.com/tutorials/serial-communication
  3. Wrong baud rate is usually due to not running at the speed you thought; check by blinking a LED to see if you get the speed you expected
  4. Difference between a crystal, and a crystal oscillatorhttps://www.avrfreaks.net/comment...
  5. When your question is resolved, mark the solution: https://www.avrfreaks.net/comment...
  6. Beginner's "Getting Started" tips: https://www.avrfreaks.net/comment...
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

John Samperi

Ampertronics Pty. Ltd.

www.ampertronics.com.au

* Electronic Design * Custom Products * Contract Assembly

Topic locked