Atmega32 reset pin proper connection

Go To Last Post
3 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

In below attached image is reset pin is properly connected or not. 

Attachment(s): 

This topic has a solution.
Last Edited: Fri. Oct 18, 2019 - 12:03 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 2


This is the recommended RST circuit for AVR 8bit:

 

 

 

Am I missing something ? is this the right ATMEGA32 ? I dont see pin 10/Vcc + 11/GND ? did you draw this package by yourself ?

 

 

This reply has been marked as the solution. 
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Moe123 wrote:
This is the recommended RST circuit for AVR 8bit

It comes from the Application Note AN2519 - AVR Microcontroller Hardware Design Considerations:

http://ww1.microchip.com/downloads/en/Appnotes/AN2519-AVR-Microcontroller-Hardware-Design-Considerations-00002519B.pdf

 

This is linked from the ATMega32 Product Pagehttps://www.microchip.com/wwwproducts/en/ATMEGA32 - under 'Documents'

 

There's a whole bunch of useful stuff there - well worth taking some time to browse.

 

NB: For instructions on how to include pictures in your post (where we can see them, like Moe123 did) rather than attaching (so we can't) see Tip #1.

Top Tips:

  1. How to properly post source code - see: https://www.avrfreaks.net/comment... - also how to properly include images/pictures
  2. "Garbage" characters on a serial terminal are (almost?) invariably due to wrong baud rate - see: https://learn.sparkfun.com/tutorials/serial-communication
  3. Wrong baud rate is usually due to not running at the speed you thought; check by blinking a LED to see if you get the speed you expected
  4. Difference between a crystal, and a crystal oscillatorhttps://www.avrfreaks.net/comment...
  5. When your question is resolved, mark the solution: https://www.avrfreaks.net/comment...
  6. Beginner's "Getting Started" tips: https://www.avrfreaks.net/comment...