i'm tired trying to blink LEDs on my custom board based on atmega128A. i'm using atmel studio 7 with ASF library and AVR ISP MKII programmer on windows 10. and i don't know where i'm doing wrong.
my hardware :has only 1 Atmega128A, and two LED connected to PIN PB5 and PB6, i'm sure MKII programmer pins are well connected to RESET, PB1(SCK) PE1(MISO), PE0(MOSI) because i can read device ID from Atmel Studio7 and program fused. no crystal is connected to xtal1 and xtal2. and i want to use internal osc. From my point of view i think fuses are well programmed to used internal osc. but it seems that the program is not loaded when i press F5.
someone can help me to know why ? you will see details of code and screen shot attached. Thanks in advance