ATiny13 Debug Wire Interface SOS

Go To Last Post
2 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Please Helppppppppppp......................................

Does anybody knows how to do this and tell me one by one all the steps.
I just bought a ATiny13 and I was so huppy that I would test my JTAG ICE mkII Debug Wire Interface.
I tried to enable the debug wire. I made all the steps to enable. I tried to program the chip with ISP and Serial High Voltage Programming to enable this bit.
Note that whenever I open the STK 500 programming window and choose the FUSES or LOCK BITS windows, I see the same message box:
Problem(s) occured when executing command(s). Please check the history window. See the troubleshooting section in help for information on what may have caused the problems.
I try the troubleshooting section but nothing seems that gona help.

Versions: AVRStudio 4.09
STK500 1.46
------------------------------------------------------------------------------------------------
Thanks, Icarus

Michael.

User of:
IAR Embedded Workbench C/C++ Compiler
Altium Designer

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Step 1: Start by reading the forum descriptions and the sticky posts at the top of each forum. This should be done BEFORE posting any questions.

Writing code is like having sex.... make one little mistake, and you're supporting it for life.