AT91SAM9X35

Go To Last Post
5 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

i install SAM-ba driver in Linux version 4.14.0 but still SAM-ba GUI not showing usb port or any j tag port...so what shall i do for the same...pl help me to resolved this issue

thanks!!!!!!!!

b_TEJAS

Last Edited: Fri. Mar 30, 2018 - 07:07 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Does the user that you run sam-ba in have permissions to the usb and jtag devices?

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Atnel wrote:

Atmel SAM-BA® software provides an open set of tools for programming the Atmel SAMA5, SAM3, SAM4, SAM7 and SAM9 ARM® core-based microcontrollers.

 

http://www.atmel.com/tools/atmelsam-bain-systemprogrammer.aspx

 

The clue is in the name: SAM-BA is for the SAM processors - not AVRs!

 

 

Top Tips:

  1. How to properly post source code - see: https://www.avrfreaks.net/comment... - also how to properly include images/pictures
  2. "Garbage" characters on a serial terminal are (almost?) invariably due to wrong baud rate - see: https://learn.sparkfun.com/tutorials/serial-communication
  3. Wrong baud rate is usually due to not running at the speed you thought; check by blinking a LED to see if you get the speed you expected
  4. Difference between a crystal, and a crystal oscillatorhttps://www.avrfreaks.net/comment...
  5. When your question is resolved, mark the solution: https://www.avrfreaks.net/comment...
  6. Beginner's "Getting Started" tips: https://www.avrfreaks.net/comment...
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

yes !!!!!!!!!!!!!!!    ......................  i'm using at91sam9x35 mcu

b_TEJAS

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hello Everyone!!!

 

I'm using An AT91SAM9X35 Mpu board. thier is need of bootloader to load an application cade above 24kb size...so i used bootloader given in keil software package for my board.they also mentioned the exact location of the user location where we have to load user program.so,I'm loading that Bootloader at 0x00 location and the application program at 0x4200 location. but still I'm not getting output..my application program is simple Blinky led program. 

 

Note: I'm using sam-ba software to load bootloader and the application program.

b_TEJAS