Early in this (multi-unit) project I had intended to mount tactile switches directly on the PCB and then mount the PCB up against the front panel. This would have allowed switch holes in the front panel that was going to use an overlay. Problem is this: the circuit now needs an Omron relay that makes tactile switches not possible because of the above-board height of the relay. Grrrr.
This project only needs 3 momentary switches and I'd like to avoid manually drilling holes in the panel and manually wiring the switches. I've looked for a standard (no NRE) 3-switch membrane switch assembly but have come up empty so far.
Any suggestions would be appreciated before the PCB design starts.