Hello, I'm new to Atmel products and AVR studio. I'm using Studio 5 with an AT32UC3A0512, and I seem to be missing something very fundamental. Normally I would expect to be able to set things like: the initial stack address, the load address for code (so I could have more than one application burned into the flash), any regions of memory that are off-limits, how to tell the programmer (JTAGICE-II) where to burn the code (perhaps that's included in the binary file), etc. The documentation indicates there's a "Memory" tab in project properties. This is the kind of thing I was expecting, except it's not there. Can someone clue me in on where I might find these settings? They're rather important.