MCP2510/5 Unable to put into Normal/Loopback mode

Log in or register to post comments
Go To Last Post
3 posts / 0 new
Author
Message
pieterc
pieterc's picture
Level: Wannabe
Joined: Mon. Mar 5, 2001
Posts: 58 View posts
Location: Cape Town, South Africa
#1
Posted by pieterc: Wed. Nov 19, 2003 - 09:32 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Anoyone with experience of this SPI CAN controller from Microchip?

I ?think? I did everything right to configure the device, but when I try to put it into normal or loopback mode, it does not comply, but stays in config mode.

Is there a specific reason for this ? Am I missing some specific register initialisation during config mode ?

Any hints would be appreciated.

Regards
Pieter Conradie

Tags:

AVR Microcontrollers, megaAVR and tinyAVR
Top
Silver Markadmin
admin's picture
Level: Site Admin
Joined: Fri. Oct 18, 2013
Posts: 53184 View posts
Posted by admin: Wed. Nov 19, 2003 - 12:31 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Im using this chip and i don´t have such problem........... did you look to the 2510 errata???? There is some important information there.........

FK

admin's test signature
 

Top
pieterc
pieterc's picture
Level: Wannabe
Joined: Mon. Mar 5, 2001
Posts: 58 View posts
Location: Cape Town, South Africa
Posted by pieterc: Fri. Nov 21, 2003 - 07:29 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I have solved my problem... there is no cure for stupidity :) I translated one of the SPI commands from binary to hex incorrectly. Thanks for the interrest!

Regards
Pieter

Top