I was using M48 for a long time now and I am using the STK500 to program this. It worked just great.
Now I moved to the M328P (which is supposed to be pin compatible with M48) and again used the STK500 to program this.
I chose the internal RC oscillator, unchecked the CLKDIV8 fuse and used 4kHz as my ISP programming frequency in AVRStudio.
When I programmed the chip, the erase went ok, it looked like it programmed the chip but once it was done programming, it gave me the Program error (the usual one where it asks you to check your connections, check ISP frequency,etc.) I get the same error when I do a verify.
I took the chip and put it on the breadboard and it looked like it was working ok. I just want to make sure if there would be any problems with this error appearing (any code reliability etc,) Should I bother fixing it? I would like to however time is very limited. (as usual)