Design own board

Go To Last Post
3 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hello,

I'm new here and I'm glad having found a forum about the AVR32. Now, waht's my concern? For my former projects I used either the 8x51 or the Mega series. But now I want to try the AVR32. Therefore I already ordered some AT32UC3A0256-ALUT. I don't want to by a plug-and-play board like grasshopper because they have to many features which I do not need. My board will simply have all necessary components to run the controller and to programm it. The power-part will be adopted from the grasshopper but I'm not sure how to design the serial interface for programming the uC. Which software (like ponyprog) supports AVR32?

Some helpful suggestions?

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

You can find the answers here:
http://www.atmel.com/dyn/product...

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

If you are looking for a one off use of the board you want to make, I would get a EVK1100 and the Needed JTAG to do the development over spending alot of time developing a board for the AVR32. I would also develop as much as possible on the EVK before changing to a custom done board.

Caleb