Compiling SAM-BA monitor for C20, specifically ATSAMC20J18A

Log in or register to post comments
Go To Last Post
2 posts / 0 new
Author
Message
aneedles
aneedles's picture
Level: New Member
Joined: Tue. Jun 13, 2017
Posts: 3 View posts
#1
Posted by aneedles: Sun. Jun 19, 2022 - 11:46 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0


Hi all,

 

I am trying to setup the SAM-BA Monitor bootloader for the ATSAMC20J18A. When I download the source and set it up to compile, I am not given the option to select this processor when I try to adjust the project properties. I am using the newest (I think) Microchip Studio (Version 7.0.2542). I select Device and then Change Device... as you can see below. The SAMC20 selection for Device Family gives no MCU options. I was hoping to see the ATSAMC20J18A among others in a list below.

 

How can I set up the project to allow for selection of the ATSAMC20J18A?

 

Thanks,

     Aaron

 

Tags:

Atmel SMART ARM-based MCUs and MPUs, Atmel Cortex-M MCUs
Top
meolsen
meolsen's picture
Level: Site Admin
Joined: Wed. Jul 27, 2011
Posts: 4052 View posts
Location: Microchip, Arizona
Posted by meolsen: Mon. Jun 20, 2022 - 12:51 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Change the supported parts drop down, but beware that code compatibility is not longer guaranteed...

:: Morten

 

(yes, I work for Microchip, yes, I do this in my spare time, now stop sending PMs)

 

The postings on this site are my own and do not represent Microchip’s positions, strategies, or opinions.

Top