Hope someone can help me.
I have just go an Atmel-ICE from a friend, i would like to use it to program AtTiny 1 Series at the moment 1614.
I cannot get the programmer to program the attiny, from Arduino IDE using the ATMEL-ICE as source.
It works if I am using an Arduino Board, but I would like to use the Atmel-ICE, and in time change to Microschip Studio.
I have installed Microchip studio and it have installed the drivers for the Atmel-ICE.
It might be my pinout, can anyone help me whit the pinout from the ICE to the 1614, so I can check?
or is there any aditional settings in Arduino IDE etc. that could be the problme?
Thanks on adwance.