Success story with LGT8F328p in linux

mariusz0

Level: New Member

Joined: Sun. Mar 20, 2011

Posts: 3 View posts

#52

Posted by mariusz0: Fri. Feb 28, 2020 - 07:49 AM

Hello . I will ask for a simple code for LGT8F328P TO use the 12BIT ADC. It's best to compile on arduino

Last Edited: Fri. Feb 28, 2020 - 09:05 AM

meslomp

Level: Raving Lunatic

Joined: Wed. May 2, 2007

Posts: 6486 View posts

Location: Nieuwegein, Netherlands

#53

Posted by meslomp: Fri. Feb 28, 2020 - 09:02 AM

there is a gitbhub link to code.

Aldobaldo

Level: New Member

Joined: Sat. Feb 2, 2019

Posts: 2 View posts

#54

Posted by Aldobaldo: Tue. May 12, 2020 - 05:01 PM (Reply to #50)

hi. did you succedes in reburning the bootloader? i did the same mistake but i'm not able to find any way to reset the board

Last Edited: Tue. May 12, 2020 - 05:02 PM

Aldobaldo

Level: New Member

Joined: Sat. Feb 2, 2019

Posts: 2 View posts

#55

Posted by Aldobaldo: Tue. May 12, 2020 - 05:03 PM (Reply to #49)

hi. did you succedes in reburning the bootloader? i did the same mistake but i'm not able to find any way to reset the board

awneil

Level: 10k+ Postman

Joined: Fri. Jul 1, 2005

Posts: 23539 View posts

Location: Basingstoke, Hampshire, UK

#56

Posted by awneil: Tue. May 12, 2020 - 05:08 PM

Top Tips:

How to properly post source code - see: https://www.avrfreaks.net/comment... - also how to properly include images/pictures
"Garbage" characters on a serial terminal are (almost?) invariably due to wrong baud rate - see: https://learn.sparkfun.com/tutorials/serial-communication
Wrong baud rate is usually due to not running at the speed you thought; check by blinking a LED to see if you get the speed you expected
Difference between a crystal, and a crystal oscillator: https://www.avrfreaks.net/comment...
When your question is resolved, mark the solution: https://www.avrfreaks.net/comment...
Beginner's "Getting Started" tips: https://www.avrfreaks.net/comment...

AVR Freaks