Problems with debugging Arduino Uno R3 with Atmel Studio 7 and Atmel ICE

Go To Last Post
3 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I have followed this official video to program and debug an Arduino sketch with the Atmel Studio 7 and Atmel ICE on the Arduino Uno.

I have followed the same tool settings but get an error message and I am not sure what settings I should be using, see attached screenshot.

Bear in mind that the chip still has the Arduino bootloader.  Any ideas?

 

Thank you

Attachment(s): 

This topic has a solution.
Last Edited: Mon. Dec 30, 2019 - 03:09 AM
This reply has been marked as the solution. 
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 1

"Dare to be naïve." - Buckminster Fuller

Last Edited: Sun. Dec 29, 2019 - 04:58 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 1

gchapman, you were right on the money.

I just cut the Reset EN trace and it worked on the first try. I had actually found this page: debugging-arduino-sketches-with-atmel-studio-7 but wasn't sure

if I needed to modify my board since the official Microchip video didn't mention it(they should really). Following the instructions in your link it became clear that the modification is necessary and the right one.

 

Thank you very much

Zeppelin