V-USB and getting detected as an Enttec USB DMX

Go To Last Post
2 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hey

 

Has anyone been able to get successfully detected in, say, QLC+ as an Enttec dongle, using V-USB? I tried just changing the Vendor and device ID's to that of the Enttec,

 

Product ID: 0x6001

Vendor ID: 0x0403

 

but opening QLC+, gives me a ftdisys related BSOD immediately. Does successful use of these ID's require me to implement some of the enttec commands on the AVR side?

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

You probably wont have any success using the FTDI VID/PID and drivers without an authentic FTDI chip. You'll have much more luck masquerading as a device which uses the libusb driver.