Missing STK500 in Device Programming

Go To Last Post
5 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

My new computer downloaded Studio 7.0.2397. I started a new project with ATMega328P but

Device Programming page only shows SIMULATOR and not STK500 for TOOL. Apparently

Studio 7 has to be told about STK500. Tried the Quick Launch tab  but no solution found.

Any suggestions appreciated.

This topic has a solution.

Skier

Last Edited: Sat. Dec 14, 2019 - 06:39 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

"Dare to be naïve." - Buckminster Fuller

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Please explain: where and how to add Non-Detectable tool | Atmel Studio 7

Skier

This reply has been marked as the solution. 
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 1

Skier wrote:

Please explain: where and how to add Non-Detectable tool | Atmel Studio 7

Click the link in post #2 above.

"Experience is what enables you to recognise a mistake the second time you make it."

"Good judgement comes from experience.  Experience comes from bad judgement."

"Wisdom is always wont to arrive late, and to be a little approximate on first possession."

"When you hear hoofbeats, think horses, not unicorns."

"Fast.  Cheap.  Good.  Pick two."

"We see a lot of arses on handlebars around here." - [J Ekdahl]

 

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 1

Now I get it.

Thanks much

Skier