Hi folks, I am using an ATxmega128A4U which is programmed using an Atmel ICE.
To make sure everything was going on correctly with the Lock Bits Programming I am doing this phase manually at the Lock Bits section.
Currently, I am programming with the value 0x56:
Boot Section - Read not allowed
Application Section - Read not allowed
Application Table - Read not allowed
Lock Bits Section - Write not allowed
Therefore I can check the Lock Bits after programming and they do burn correctly.
The problem arises when I try to update the application (update the firmware) without erasing the chip: it does not update anything...
Does anyone have any idea about what is happening?
Thank you for your time, Felipe.