I am completely new to the Atmel environment. I have to setup the hardware for an assignment. I have connected AVR ONE with Atmel ® UC3-A3 Xplained board using JTAG interface. I am using Atmel Studio 7 IDE. Before doing programming, I wanted to make sure if the target is connected to AVR ONE programmer. I can read the target voltage but not the device signature. I am getting the following error.
Communication error. Try with a lower clock speed. Debugger command setEmulatorMode failed.
Unable to enter programming mode, Verify device selection, interface setting, target power, security bit and connections to the target device.
Can someone help me on this issue? Am I missing something?