Atmel Studio can not detect EDBG for debugging in SAM E70 Xplained evaluation kit

Go To Last Post
5 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I bought a SAM E70 Xplained evaluation kit a few days ago, and I am trying to use it.
But when i click "Debug" -> "Start without debuggging", it shows a message box, says "Please select a connected tool and interface and try again" (attatchment 0.png)
And i'm sure that the correct device was selected (attatchment 1.png)
And there's no EDBG tool in tool list (can not detect) (attatchment 2.png)
But actually I can see the EDBG in the "Available Tools" Window (attatchment 3.png)
And I can also  see the EDBG in the "Device Programming" window, and it returns the right information (attatchment 4.png, 5.png)
The firmware of EDBG was upgraded to the lastest version 3.25
I was stucked on this problem, please help me.

Attachment(s): 

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Your project is using a B Device, while the kit has a non-B device.
.
Change the device in your project and you should be good to go...

:: Morten

 

(yes, I work for Atmel, yes, I do this in my spare time, now stop sending PMs)

 

The postings on this site are my own and do not represent Microchip’s positions, strategies, or opinions.

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Thank you! meolsen, Thanks again.

It works OK now when the device is changed to ATSAME70Q21  (none-B).

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I have a similar issue. but even after changing the device its the same

 

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

same issue board is not detected by atmel studio 7.

<p>rutwik</p>