Reading Target voltage fails

Log in or register to post comments
Go To Last Post
4 posts / 0 new
Author
Message
meslomp
meslomp's picture
Level: Raving Lunatic
Joined: Wed. May 2, 2007
Posts: 5834 View posts
Location: Nieuwegein, Netherlands
#1
Posted by meslomp: Wed. Jan 16, 2019 - 09:28 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

It might be a default setting that is wrong, but there is something strange happening.

I have encountered this both at home using an AVR-ISP MKII (AVR8 bit processors) and now at work with an Atmel ICE ( ARM ).

 

When I use the device programming dialog ( Tools -> Device programming ) I select the appropriate processor + Interface and press " apply" 

Then I just want to read the Target voltage and press the Read button:

I get an error message:

and the target voltage does not show:

 

But when I want to read the device signature and thus press that "Read" button the target voltage is shown and the device ID too

 

I wonder if this is some setting that I set wrong, or if this is actually a bug in studio....

 

 

Tags:

Tools, Atmel Studio (AVR-related)
Top
ka7ehk
ka7ehk's picture
Level: 10k+ Postman
Joined: Fri. Nov 22, 2002
Posts: 20486 View posts
Location: Tangent, OR, USA
Posted by ka7ehk: Wed. Jan 16, 2019 - 04:52 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I've seen the same behavior. My hunch is that it is a bug, either in the programmer or the driver for the programmer.

 

Jim

Jim Wagner Oregon Research Electronics, Consulting Div. Tangent, OR, USA http://www.orelectronics.net

Top
meslomp
meslomp's picture
Level: Raving Lunatic
Joined: Wed. May 2, 2007
Posts: 5834 View posts
Location: Nieuwegein, Netherlands
Posted by meslomp: Thu. Jan 17, 2019 - 07:45 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

ka7ehk wrote:

I've seen the same behavior. My hunch is that it is a bug, either in the programmer or the driver for the programmer.

 

Jim

Thanks, that at least makes me not insane, hahahahaha

hope a couple of others can confirm too. then I will see if I can get a bug report out.

just had a quick look at the microchip website, but that is going to be an interesting experience when I have to dive into it, hahahaha.

Top
Grannus
Grannus's picture
Level: Wannabe
Joined: Mon. Sep 19, 2016
Posts: 72 View posts
Posted by Grannus: Thu. Jan 17, 2019 - 08:11 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

meslomp wrote:

hope a couple of others can confirm too.

 

+1 can confirm.  But I assumed it was an operator error on my part. It normally is.  :-)

Top