I am using the ATTINY2313, and I read in the datasheet that I can program the lock bits to prevent my firmware from being read, thus protecting my firmware.
Basically, I want to program the LB2 and LB1 bits so that " Further reading and programming of Flash and EEPROM is disabled in parallel and serial programming mode. Fuse bits are locked in both serial and parallel programming mode."
1) Does the above also mean that my firmware won't be able to access the statically declared data via PROGMEM during runtime?
2) And, if my firmware reads/writes the EEPROM internally, this will disabled as well, again, during runtime?
3) I should be still able to use the /RESET pin to reset the ATTINY?