Programming mode failed

Go To Last Post
3 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hi,

I don't seem to be able to program any AVR's from my Dragon. When i go into the board tab I get everything ok (see picture 1), when I try to read the fuses i get an error pointing to ISP freq (see picture 2) which i have tried all options and still get an error. Then when i try going back to the Board tab i get an error (see picture 3) and have to reset everything to get back to all ok in the tab. Also i have used new out the tube IC's at least 3. :x

I have tried Atmel support but they have not been able to help yet just wondering if anyone here can help

Attachment(s): 

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Try setting your ISP frequency to 125Khz. 100hz is a little slow.

Pete

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I tried that still did not work, i decided to buy some more IC's and now they work. I must of had some dodgy micro's