In Atmel Studio 7 under Device Programming it shows my device "mEDBG ATML2678....." for the tool, ATtime104 for the Device and TPI for the interface. When I click on Apply I get a popup message that mEDBG firmware must be updated before continuing from 1.01 to 1.07. I click on Upgrade and it comes back that mEDBG firmware successfully upgraded.
Then the Tool shows as "mEDBG[Disconnected] ATML2678....". When I click on Apply I get an error that it's unable to connect to tool mEDBG (ATML2678....) with details of: componentid of 20000, status code of 0 and message of "The tool specified has been disconnected. Please reconnect the tool or choose another one".
So I unplug the USB cable and reinsert so that the Tool now shows mEDBG with the device (No disconnected message). When I click apply the message to upgrade the firmware comes back up, putting me in a firmware upgrade loop.
Am I doing something wrong or is there something going wrong with the firmware update to mEDBG on this ATtiny104 Xplained Namo? By the way, I purchased two of these boards and have used two different USB cables, all with the same results as above.
Thanks in advance for any help!