Can't debug my Arduino Nano with Studio 7

Go To Last Post
3 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Eek!

 

I imported and built my sketch. Programmed the arduino using my Atmel ICE. Of course the program isn't working, that's why I'm trying to debug.

 

 

But when I try to debug, It says:

 

 

So, I answer Yes:

 

 

Since I can read the device signature and verify the program, I imagine the reset line is working....

 

What version of Studio?  Um 7.0.1188

 

 

 

 

If you don't know my whole story, keep your mouth shut.

If you know my whole story, you're an accomplice. Keep your mouth shut. 

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Two "modifications" are involved for a Nano:

1.   remove 100nF DTR capacitor or cut track.

2.   remove 1k Reset pullup resistor or replace with 10k pullup

 

As far as I can see,  the Nano was specifically designed to upset intelligent ICSP programmers by having an extra-strong pullup.

And obviously upset debugWIRE both with 100nF and with strong pullup.

 

David.

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Ah! The dastardly thing!

If you don't know my whole story, keep your mouth shut.

If you know my whole story, you're an accomplice. Keep your mouth shut.