Good day to all,
Im new to Atmel Studio and bough an Atmel SAM V71 Explained Ultra evaluation board and installed the Atmel Studio (version 7.0.1188) on my Windows Machine.
I installed the EDBG Virtual Com port driver and when I go to the Tools->Device Programming (select the EDBG tool)->Memories i can program and verify that the image has been successfully programmed into the board flash.
However, when I try to debug or run an application, the studio complains about the need to select a programmer. It opens a new tab and in the Tool->"Selected debugger/programmer" I select the "Custom Programming Tool" (which is the only option available). When I try to run the application again it complains that the custom programming tool has not been defined. My question is: what should I place in the "command" of the custom programming tool? Or is there a default programming tool that somehow Atmel Studio is not giving me?
I do not have an installed programmer and was hoping that Atmel Studio provided this programmer.
Thank you in advance and kind regards,