I am having trouble programming my Tiny2313 with the JTAG Mk II. I have
previously used serial programming without problems. However my new
very fast desktop computer has NO serial ports!! I have seen this with
laptops but now desktops as well.
I followed the thread with BPar about setting the debugging platform. I have tried to set the DWEN fuse but I get the error as follows:
Getting Revisions OK
Reading Target voltage OK
Getting ISP Frequency paramaters FAILED
The the pop up says
Check that the ISP programming frequency is well below 1/4 clock.
I am using a 7.328 MHz crystal on my STK 500 and have tried setting the
frequency to just about everyone available.
If this is a problem of setting the DWEN fuse, how does one go about that
without a serial cable?
This is becoming quite frustrating so I would appreciate any help that can