Lufa winusb compatibility

Go To Last Post
3 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Dear Developers, 

Hi ,

For a project based on atmega32u4 chip (Leonardo arduino board), I need to connect my board to windows 8.1 OS.

For firmware side, I use LUFA project.

I downloaded and installed wdK ( windows driver kit) to use winusb general driver to handle data transfer of my board.

 

But windows pushes some rules for devices to be Microsoft winusb compatible.

Please have a look at following links:

https://msdn.microsoft.com/en-us...(v=vs.85).aspx#how_to_configure_a_winusb_device

 

Now it seems I have to change descriptor table of USB firmware.

But before start I would like to know if somebody have done it previously and I do not reinvent the wheel again.

 

Best Regards,

Mehrdad,

 

This topic has a solution.
Last Edited: Tue. Feb 23, 2016 - 06:58 AM
This reply has been marked as the solution. 
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hi guys

I find something that may help.

 

https://github.com/pbatard/libwd...

 

It shows a sample for lufa which is windows compatible. 

 

 

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

mehrdad_58 wrote:

I find something that may help.

 

https://github.com/pbatard/libwd...

 

I used the pbatard stuff, and I did look at LUFA.

Winusb is good.  No complaints.  Much better than that half-baked Microsoft CDC driver.