XMEGA A1 the dreaded VCC GND pair swap

Log in or register to post comments
Go To Last Post
3 posts / 0 new
Author
Message
lagger
lagger's picture
Level: Hangaround
Joined: Sun. Sep 4, 2005
Posts: 194 View posts
#1
Posted by lagger: Thu. Mar 19, 2015 - 09:40 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

As some of you may have also learned the hard way, I managed to produce a board where VCC goes to pin 83 and GND goes to pin 84. (VCC pins are 3, 13, 23, 33, 43, 53, 63, 73, 84, 93, GND pins are 4, 14, 24, 34, 44, 54, 64, 74, 83, 94)

 

Does the chip function 100% with that pair of pins cut?

This topic has a solution.

Tags:

AVR Microcontrollers, AVR and XMEGA, ATxmega128A1, ATxmega128A1U
Last Edited: Thu. Mar 19, 2015 - 09:41 AM
Top
leon_heller
leon_heller's picture
Level: Raving Lunatic
Joined: Fri. Jul 27, 2001
Posts: 7672 View posts
Location: St. Leonards-on-Sea (UK)
This reply has been marked as the solution. 
Posted by leon_heller: Thu. Mar 19, 2015 - 09:47 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 1

All Vcc and Gnd pins should be connected. Run wires to the pads to connect them.

Leon Heller G1HSM

Top
Torby
Torby's picture
Level: 10k+ Postman
Joined: Tue. Nov 11, 2003
Posts: 10386 View posts
Location: Bartlesville Oklahoma USA
Posted by Torby: Fri. Mar 20, 2015 - 12:52 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Yup. I fear you're going to have to cut and wire each one. Alas.

 

If you don't know my whole story, keep your mouth shut.

If you know my whole story, you're an accomplice. Keep your mouth shut. 

Top