I'm programming a Atxmega8E5 on my own board. The Avr Dragon can read, it says that can write but when verify it fails so I think it is not writing to the flash.
Since it has only one line to read/write it is odd :s
Where should I look to problems?
Put the multimeter probes between ground and reset to see if it goes gnd and with the probe on that lines it can program :s
Remove the 10kohms resistor like in the xmegaE5 xplained board but it only with the multimeter probes on it I can program it.
Only a multimeter probe on reset line is suficient so without it the reset line should be floating?
Now it the R1-10k was removed.