Schematic/details for STK600 power supply regulation!?

Go To Last Post
4 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

...I JUST finished uploading the final code for a prototype that is supposed to be shown at a trade show tomorrow. I'm using the STK600 inside the prototype unit. After I just finished I also just managed to damage the power supply regulation. Does anybody have any info on the STK600 power supply? I can't find a schematic - which is ridiculous for an evaluation board.

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

...I did findthe schematic for the 2560 MCU card and I may need to wires directly to the copper on the back of the card (the firmware is done and uploaed already.

What do I need besides power ground and crystal? What about the reset line?

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

...just in case someone else has a similar problem there's a swtiching stepdown regulator w/ related resistors and inductors just to the right of the 90USB1287. It's a small SMD part stamped 93W. It's after the initial 6V regulation at the power input. This part is bad in mine. Since I don't have time I had to remove the 2560 card and wire it up by itself along with a crystal hanging off and resistor/cap to make the reset line happy. Pain in the butt... This board sucks. Between the power conditioning, no schematics, and no f'ing holes to mount the thing what a joke for $200.

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Quote:
This board sucks. Between the power conditioning, no schematics, and no f'ing holes to mount the thing what a joke for $200.

Fairy Tail for you.

No RSTDISBL, no fun!