DT006 (Little rAVeR)

Updated: Jan 20, 2005

Description

The DT006 board will program the AVR 8, 20, and 28 pin DIP chips on board, and will also program the DT107, (8515 and 4433 footprint) DT104, (2313 footprint) and SIMM100 (8535 footprint) AVR SimmSticks, as well as any AVR target board that has a Kanda type header. Current burning software is achieved with the programmer software built into Bascom-AVR. and Codevision C. Check Bascom-AVR and Codevision documentation for chip types supported.

This means, after you have this programmer unit up and running as a development platform, all you need to duplicate the procedure with a stand alone micro, is a single AT90S2313-10-PC micro, and a DT104 PCB and a handful of simple components. Or you can use your own circuit design on a proto board, vero board, your own artwork, whatever.

SimmStick Compatible. Programs from the parallel printer port of a PC. Serial port is for RS-232 Comms.

Has a "Kanda" standard header on board, so it can be used as a programmer for target boards that have this header, or can be used as a target board for any Programmer that has the same "Kanda" header.

Expansion of all Simm Bus signals can be done via the 30 pin expansion bus, so that proto, or vero boards can be hooked up very easily, and cheaply.

Available assembled and tested or in kit form. Price given is in approximate USD for the kit.

URL's:
http://www.dontronics.com/dt006.html
http://www.dontronics.com/dt104.html
http://www.dontronics.com/dt107.html
http://www.dontronics.com/simm100.html
http://www.dontronics.com/runavr.html
http://www.dontronics.com/basc-avr.html
http://www.dontronics.com/cvavr.html

Some devices listed below may need adapters, or plug-in standard SimmSticks.
Not all devices are Supported by Bascom-AVR (No Ram devices)
All devices are supported by Codevision C.
Check Imagecraft also for device types supported by the DT006.

Categories

• Development Board
• Programmer : Parallel