From the datasheet description, I see that I can configure timers in waveform mode, and TIOA and TIOB become outputs for the generated waveform (e.g., see Figure 28-5 on page 758 of the complete datasheet).
However, I cannot find documentation about how to map TIOA or B to a physical pin. Are there designated pins? I was expecting to find TIOA and TIOB in table 3-1 on page 9, but I don't see them there.
Any help/pointers will be appreciated.
For context: I want to generate a 4 or 8MHz square-wave signal that will be the clock for an external peripheral chip. (I have the 12MHz crystal for the UC3-A3 internal oscillator)