[Tut][C][Code] LUFA & Studio5 - Beginner's Guide, Part 2

Go To Last Post
5 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

LUFA & Studio5 - Beginner's Guide,
Part 2: Modifying VirtualSerial for OLIMEX162 Board

In Part 2, the Studio5 project that was built in Part 1 will be modified to work with the OLIMEX162 board that uses the at90usb162 microcontroller.

Part 1 can be found here:
http://www.avrfreaks.net/index.p...

The tutorial is in the attached pdf and the software files in the attached .zip
(You need to be logged in to download the attached files.)

Attachment(s): 

Last Edited: Mon. Sep 19, 2016 - 07:53 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0
Chuck99 wrote:
LUFA & Studio5 - Beginner's Guide,
In Part 2, the Studio5 project that was built in Part 1 will be modified to work with the OLIMEX162 board that uses the at90usb162 microcontroller.

The tutorial is in the attached pdf and the software files in the attached .zip

Works perfect, but be careful to download the modified files attached to the post.

Very good starting point for a beginner wanting to use the Olimex Board.

Pierre :P

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hello, thanks for this tutorial!!!

Unfortunately I'm not able to download the zip file.
Would you post this again?

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

uilterwitte wrote:

Hello, thanks for this tutorial!!!

Unfortunately I'm not able to download the zip file.
Would you post this again?

 

I restored the zip file to post #1.

 

Please keep in mind that this tutorial was written back in 2012. 

Both LUFA and Atmel Studio have changed since then.

 

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Thanks for your quick reply!

It will be very helpful for me.