SAMD20 with Atmel Studio 7 memory map issue

Go To Last Post
4 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hi All,

I have developed a custom board using SAMD20E15 and I am facing a serious issue with the Atmel Studio IDE. I am able to compile the code but the memory map used by Atmel Studio is for SAMD20J18 (Xplained Pro Board). Due to this my code is going into dummy handler ISR routine and I am not able to run the code in TARGET board. 

I would like to get help on how to adjust the memory map for SAMD20E15 target device. Also what all things to be taken care of when developing a custom project.

Thanks in advance.

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

It's not clear if the problem is only that you are building for the wrong device. Just change device if this is the case, you do that from the project properties.

/Lars

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Lajon wrote:
Just change device if this is the case, you do that from the project properties.

I'm not sure that changing the device in an existing project does actually update the rest of the project ...

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

There is not much to change with SAMD20J18 -> SAMD20E15, I have done similar for D21 without problems.

/Lars