Please help me identify this MCU

Go To Last Post
7 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Can anyone help me identify this MCU?

It is Marked RM80F0308AS or Possibly just M80F0308AS

 

It seems to have a very similar pin out to the MC80F1608 from ABOV Semiconductor.

What I really want to do is find the correct compiler and in-circuit programmer for it, so I can re-program the device.

SpiderKenny
@spiderelectron
www.spider-e.com

 

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Errr, what happens if you click on the 'development tools' tab on the page you linked to?

'This forum helps those who help themselves.'

 

pragmatic  adjective dealing with things sensibly and realistically in a way that is based on practical rather than theoretical consideration.

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Aye, but I'm not 100% sure if that is the same device, or even the same family. 

Hence I was reaching out to see if anyone can positively identify the device.

SpiderKenny
@spiderelectron
www.spider-e.com

 

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Well there are MC80F0308 but they are 28 or 32 pin packages.  It is obviously a new device 17 week 22 so what is the board that it sits on? 

 

David

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

DAFlippers wrote:
what is the board that it sits on? 

+1

 

and how do you know that it even is a microcontroller ?

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I wouldn't pay too much attention to the prefix. ABOV started life as Hyundai with that chip family first appearing in 1996. In 2001 they became Hynix, in 2004 they became Magnachip and ABOV in 2006.

'This forum helps those who help themselves.'

 

pragmatic  adjective dealing with things sensibly and realistically in a way that is based on practical rather than theoretical consideration.

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

 

awneil wrote:

DAFlippers wrote:

what is the board that it sits on? 

 

+1

 

and how do you know that it even is a microcontroller ?

It definitely is an MCU, and unfortunately I cannot say anything about the board that it sits on at the moment.

It is from a pre-production prototype run. The functions this controller controls are a little buggy, and the code will be fixed in the production run, but I'd like to re-program the prototypes. I did not design the board, nor did I spec the MCU, but I do have to make them work.

 

SpiderKenny
@spiderelectron
www.spider-e.com

 

Last Edited: Tue. Nov 14, 2017 - 04:29 PM