JTAG Programming

Go To Last Post
3 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hi, I am using the STK600 kit to interface with a AT33UC3C0128C micro controller and when I attempt to program using Studio 6 I receive the following error:

"Unable to enter program mode"

Unable to activate physical interface for device.

I wanted to verify the attached configuration if correct for programming using the JTAG interface.

I have run the JTAG cable, but am confused about where the VTARGET jumper goes, or if it is even necessary.

Thank you.

Attachment(s): 

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

The vtarget jumper needs to be connected.

Set the STK600 to output 3.3V and set the clock at 16Mhz(optimal)(Bootloader uses it)

Flip the clock switch to EXT

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

lets see what happens